English (United Kingdom)
Español
Bluelab Sample Tube and Fitting
No. d'article
09-445-460
The Bluelab Sample Tube is perfect for reservoirs located more than 2 metres (6’ 6”) from your controller / monitor unit, and thus out of range of the probe leads. Pipe your nutrient solution through the Sample Tube and place the probes into the tube ports for direct measurement of nutrient
Lire la description complète
Description
The Bluelab Sample Tube is perfect for reservoirs located more than 2 metres (6’ 6”) from your controller / monitor unit, and thus out of range of the probe leads.
Pipe your nutrient solution through the Sample Tube and place the probes into the tube ports for direct measurement of nutrient solution parameters.
Fittings included.
Key selling points:
Technical Specifications:
FAQs:
Q: How should I set up my Bluelab Sample Tube?
A: Mount the Sample Tube vertically, with the drain valve at the lower end. Connect the pumped feeder hose from your nutrient reservoir to the bottom inlet fitting of the Sample Tube, and a return hose from the outlet fitting to the reservoir. Insert probes as descibed in the instructions. Note: If you are using both a Bluelab Guardian Monitor and a Bluelab Pro Cpntroller, you will need two Sample Tubes, mounted inline, one above the other.
Purchase this with…
Pipe your nutrient solution through the Sample Tube and place the probes into the tube ports for direct measurement of nutrient solution parameters.
Fittings included.
Key selling points:
- Compatible with:
- Bluelab Guardian Monitor
- Bluelab Guardian Monitor Connect
- Bluelab Pro Controller
- Perfect for reservoirs located more than 2 metres / 6.6 feet from your controller unit. Place probes directly into the tube ports for direct measurement of nutrient solution
- Fittings included
Technical Specifications:
- Maximum system pressure 1.03 bar (15 psi)
- Inlet / Outlet hose connections – male Ø13mm (0.5”)
- Integral drain valve with Ø13mm (0.5”) hose connection
- Included fittings:
- 2x 1” female thread x 1/2” male hose fitting
- 1x Plug for the temperature probe port (when not in use)
- 2x Mounting clips
- 2x 25mm (1.0”) Pan Pozidrive screws
FAQs:
Q: How should I set up my Bluelab Sample Tube?
A: Mount the Sample Tube vertically, with the drain valve at the lower end. Connect the pumped feeder hose from your nutrient reservoir to the bottom inlet fitting of the Sample Tube, and a return hose from the outlet fitting to the reservoir. Insert probes as descibed in the instructions. Note: If you are using both a Bluelab Guardian Monitor and a Bluelab Pro Cpntroller, you will need two Sample Tubes, mounted inline, one above the other.
Purchase this with…
- 09-445-355 - Bluelab Guardian Monitor
- 09-445-360 - Bluelab Guardian Monitor Connect
- 09-445-365 - Bluelab Guardian Monitor Connect Inline
- 09-445-405 - Bluelab Pro Controller
- 13-630-750 - 13mm LDPE Pipe - 50m
Spécifications
| UK RRP | £217.20 |